The manual button MCI 323, each time it is pressed, generates a transit synchronized with the system’s clock. MCI 323 provides therefore an essential accessory for a professional timekeeper in which case, during an event, must give a passage to a competitor who, for example, had not installed a transponder. The MCI 323 is also used when the type of event does not provide for the use of transponders for which you run a manual timing. MCI 323 is made of anodized aluminum of blue color and is easily connectable to myWER receiving systems (for example to the MCI 330 thanks to a robust cable 1,5 meters long).
WARNING ! prices and products valid in Europe, for international proposal: sales@mywer.it
The active coaxial adpater MRD 250 allows myWER receiving systems to connect to all the facilities already wired in analog technology with coaxial cable and a BNC connector. Using the MRD 250 is very simple: just connect the coaxial cable to the BNC connector and the myWER reader to the other two cables. The adapter is powered by the accessory cable present on all myWER reader or external 12Vdc power.
NOTE: myWER recommends using its digital technology with digital cable which provides for connecting the Reader directly to Detection Loop to ensure a high immunity to noise and interference.
WARNING ! prices and products valid in Europe, for international proposal: sales@mywer.it
The MRD 161 synchronizer allows you to synchronize up to four myWER reception systems without using GPS systems. It is an indispensable accessory when it is necessary to handle a composite system, for example from: No. 1 Finish Line, No. 1 Intertempo, No. 1 Pitlane In, No. 1 Pitlane Out
NOTE: MRD 161 is exclusively supported by Solution Timing Management Software by KART2000.
WARNING ! prices and products valid in Europe, for international proposal: sales@mywer.it
The MET 330 ethernet module allows you to add a network port to the MCI 33x, MCD 43x series decoders when it requires a TCP IP connection via LAN. Connecting the device is very simple, just plug the cable between the socket on the back of the decoder and the socket on the back of the ethernet module. A bright OLED display and two buttons on the front allow you to totally configure the device. MET 330 is powered directly from the MCI 33x, MCD 43x series decoder.
WARNING ! prices and products valid in Europe, for international proposal: sales@mywer.it
